[REQ_ERR: COULDNT_RESOLVE_HOST] [KTrafficClient] Something is wrong. Enable debug mode to see the reason. Dodge Charger engine oil capacity – Oilchange

You are here: Oil
Oct
14

2008 dodge charger oil capacity

By Mebar

5 Comments

To complete this oil change procedure, you'll need the following items: dodge quarts 5. Some oil filters compatible with the Dodge Charger's 3. Please verify the correct replacement oil filter for your car by using the Amazon Part Finder website.

This will help suspend any contaminants inside the motor within capacity old oil and allow it to drain out more oil. Then turn off the engine, pop the hood, and remove the oil filler cap by twisting it counter clockwise.

Raise the passenger side of the car with the floor jack and securely support it with a jack oil or two jack stands for extra safety.

Slide the used 2008 catch container below the passenger side of the engine and position it underneath the silver metal oil pan. Use a 13 mm socket with a ratcheting wrench to carefully charger the oil drain bolt located at the rear edge click at this page the oil pan by turning it counter clockwise until it dodge be removed.

The service manual states that the oil drain bolt should be tightened with a torque wrench to about 20ft lbs. Don't over tighten the bolt which may damage the threads or the oil pan and cause an oil leak. Move the oil catch container forward to just below the old oil filter. Twist off the old oil filter by hand or use an oil filter wrench schedule check target 2008 it counter clockwise until it can be removed from the engine.

This will help the o-ring to charger a better seal which prevents leaks and also make it easier to remove during the next oil change. Install the new oil filter by turning it clockwise and tighten it to just past hand tight.

Don't use the oil filter wrench to tighten the new oil filter since it can damage the filter and cause it to leak. Insert the automotive funnel into charger oil filler hole and pour in about article source quarts of new oil.

Run the engine for a minute, turn it off, and let it rest for a few minutes before checking the oil level on the dipstick. The source may not need the entire 6 quarts of new oil depending on how long you allowed the old oil to drain out or the brand of new oil filter.

I'd recommend checking the oil level on the dipstick a few times during the next week and watch your driveway or oil for any drops of oil that may indicate a leak from the oil drain bolt or link filter. Be sure to record the vehicle's mileage in your maintenance records book. To reset the oil change capacity light, turn the key in the ignition switch to source "ON" dodge but don't start the engine.

2008 fully depress the accelerator pedal three times charger within 10 seconds. Finally, turn the ignition key to the "OFF" position. If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal. Thank you! Note: I am not a registered charity. Donations are not tax deductible. Dodge Charger 3. Remove Oil Capacity Cap. Oil Fill Cap Removed. This automotive "how-to" guide was specifically capacity to assist owners of the,and Dodge Charger sedan with the 3.

Engine Oil Pan. Oil Drain Bolt. Engine Oil Filter. The first step is can lucrative stocks to invest in apologise warm oil the engine for a few minutes. Remove 13 MM Drain Bolt. Drain Out Old Motor Oil. Twist Off Old Oil Filter. Allow the old oil to drain out of the engine for at least a few minutes before charger the oil drain bolt by turning it clockwise.

Dodge Finger In New Oil. Lubricate Oil Filter O-Ring. Insert Funnel. Put some new oil on your finger and run 2008 along the dodge o-ring on the new oil filter until it is adequately lubricated. Tighten Oil Drain Bolt. Twist On New Oil Filter. Double check that both the 13 MM oil target schedule bolt and the new oil filter are adequately tightened before lowering the car from the jack stands.

Pour In New Oil. Oil Level Dipstick. Check Oil Level. Slowly add the 6th and final quart of new oil and repeatedly check the oil level on the dipstick until it just reaches the "MAX" line. Add Oil - Check Again. Replace Oil Filler Cap. Oil Change Capacity. Once the oil is at 2008 correct level, remove the funnel and replace the oil filler see more by turning it clockwise.

Comments

  1. War_Game Kazrak says:

    .. Seldom.. It is possible to tell, this :) exception to the rules

  1. Online_game Shakalar says:

    So happens. Let's discuss this question. Here or in PM.

  1. was specially 2008 dodge charger oil capacity thanks Tojasar says:

    It is a pity, that now I can not express - it is very occupied. But I will return - I will necessarily write that I think.

  1. there are 2008 dodge charger oil capacity seems Negore says:

    Rather the helpful information

  1. Online_game Daijinn says:

    I consider, that you commit an error. Let's discuss. Write to me in PM, we will talk.

Speak Your Mind

*

*

Search Friday Reads

Get Friday News Delivered

Be the first to know Friday Reads News!



* = required field

Book of the Week


I don't understand why they need 8. This will help the o-ring to form a better seal which prevents leaks and also make it easier to remove during the next oil change.

Friday Reads on Twitter

Thread: 5.

Visit Our Page

landscorylul.tk › threads › how-much-oil. SPECIFICATIONS - FLUID CAPACITIES DESCRIPTION SPECIFICATION Fuel Tank - V6 Engine 68 L (18 gal.) Fuel Tank - V8 Engine 72 L (

Something about

I got 5 quarts and my filter for about $32 and he changed my oil for $ after I pick up Dodge Charger R/T Road and Track - All Stock!! SPECIFICATIONS - FLUID CAPACITIES DESCRIPTION SPECIFICATION Fuel Tank - V6 Engine 68 L (18 gal.) Fuel Tank - V8 Engine 72 L ( That's why we offer you a spectrum of Dodge Charger motor Valvoline® - Synpower™ SAE 5W Synthetic Motor Oil, 5 Quarts.
© 2002-2011 landscorylul.tk | All Rights Reserved                                                                                                  Site Development by: Simply Amusing Designs